3-28
MACHINE CONTROLS
SY60C Excavator OMM
CAUTION
When open, the windshield must be secured to
the ceiling of the cab. If it is not secure, the
windshield may slide down unexpectedly and
result in injury or damage to the machine.
4.
While sitting in the operator seat, press both latches
(3). Pull the windshield toward the operator seat to
disengage the latches.
0002785
Figure 3-57
5.
Grasp the lower handhold (4) and the upper
handhold (5). Slide the windshield up to the ceiling of
the cab.
0002819
Figure 3-58
6.
Push the windshield toward the back of the cab to
engage the latch (3) in the locking bracket (6).
NOTE:
Both latches must engage the locking bracket to
properly secure the front windshield in the open
position.
Closing the Windshield
0002764
Figure 3-59
CAUTION
Close the front windshield slowly to avoid injury
or machine damage.
1.
Before closing the windshield, park the machine on
level ground, lower the work equipment to the
ground, and stop the engine.
2.
Move the hydraulic lockout control lever (1) to the
locked (closed) position.
0002820
Figure 3-60
NOTE:
The right side windshield latch is shown. The left
side windshield latch is similar.
3.
While sitting in the operator seat, press both latches
(2). Push the windshield up and forward slightly to
disengage the windshield guide roller (3) from the
track.
5
4
3
6
1
2
3
