4-36
MACHINE OPERATION
SY60C Excavator OMM
0002950
Figure 4-14
8.
Stop the machine when it travels over the rear
wheels of the trailer and toward the ramps.
9.
Adjust the boom-arm angle between 90° and 110° (3)
and lower the bucket so that the flat surface is in
contact with the ground.
0002952
Figure 4-15
10. Drive the machine slowly onto the ramps.
11. Operate the boom and the arm slowly when the
machine is on the ramps. Allow the machine to
descend slowly until it comes in contact with the
ground.
Lifting the Machine
WARNING
• Make sure all lifting devices are in safe operating
condition and with sufficient capacity rating to
safely support the intended load.
• Never lift the machine with a person inside the
cab.
• Allow no one to stand close to or under a lifted
machine.
• Always lift with the longitudinal centerlines of the
upper structure and undercarriage parallel to
each other.
• Keep the hydraulic lockout control lever in the
locked (closed) position to prevent unexpected
movement of the machine.
Failure to follow these warnings could result in
death or serious injury.
NOTE:
The lifting procedure applies to standard
machines. Check operating weight of the
machine, see “Technical Specifications” on
page 6-4.
0004525
Figure 4-16
1.
Park the machine on firm, level ground, raise the
dozer blade, and swing the upper structure to the
rear of the machine.
0002954
Figure 4-17
3
