5-16
MAINTENANCE
SY60C Excavator OMM
Fuses
Access the Fuse Panel
If an electrical component fails, check the fuse first. The
fuse and relay box is located behind the operator’s seat.
007835S
Figure 5-14
NOTE:
Always turn the battery disconnect switch to off
before checking or replacing fuses.See “Battery
Disconnect Switch” on page 3-21.
1.
Move/ tilt the seat forward to provide room to access
fuse access panel (1).
2.
Pull on tabs (2) and remove the fuse access panel.
0007836S
Figure 5-15
3.
Remove the transparent protective cover (3) by
gently pulling out on the bottom of one of the four
latches (4) while lifting up the adjacent corner of the
cover. Repeat for the other three tabs to release the
cover.
Fuse Replacement
0002857
Figure 5-16
1.
Use the fuse removal and installation tool (1) to pull a
blown fuse and install a new fuse.
2.
Spare fuses (2) can be used for replacing a blown
fuse. Always replace a fuse with a fuse of the same
amperage rating.
Fuse Circuits
1
2
3
4
4
Fuse
Amperage
Circuit
F1
25 Amp
Starting
F2
10 Amp
Battery charging
F3
15 Amp
Dome light and horn
F4
25 Amp
Work light
F5
15 Amp
Wiper, washer, and radio
F6
5 Amp
Climate control panel
F7
10 Amp
Global Positioning System
(GPS)
F8
20 Amp
Climate control system fan
F9
10 Amp
Cigarette lighter
F10
10 Amp
A/C compressor
F11
25 Amp
Monitor controller
F12
25 Amp
Fuel pump
F13
20 Amp
Unused
F14
15 Amp
Unused
K5
K8
K6
K12
K13
K9
K3
K7
1
2