3-34
MACHINE CONTROLS
SY60C Excavator OMM
Sound Mode Adjustment
0002900
Figure 3-68
NOTE:
The sound mode adjustment option is displayed
on the LCD (2).
The audio selector button (SEL) (1) is used to adjust the
sound quality. Each time the button is pressed, the
display will cycle adjustment options as follows:
• Pres and hold the SEL button to access the bass
(BAS) level adjustment.
• Pressing the button again allows access to the
treble (TRE) level adjustment.
• Pressing the button again allows access to the
balance (BAL) (between the in-cab speakers)
adjustment.
When the desired audio option is selected, use the
volume buttons (4 or 5) to adjust the selected audio level.
NOTE:
Press and release the power button (3) to mute
the radio. Press and release the power button
again to un-mute the radio.
If a button is not pressed (no adjustment made) after 5
seconds, the LCD will default to show the current radio
station frequency.
Time Adjustment
0002900
Figure 3-69
1.
Press the time button (1) to display the current time
on the LCD (2). The display will return to radio
frequency after 5 seconds.
2.
To set the hours, press and hold the TIME button
until the hour numbers flash and a beep is heard.
3.
Press tuning buttons to set the hours.
4.
To set the minutes, press the TIME button (1) until
the minute numbers flash.
5.
Press tuning buttons to set the minutes.
6.
Press and release the TIME button after the time is
set.
Antenna
0002861
Figure 3-70
If the radio signal received is weak or noisy, raise the
antenna (2) on the right rear of the cab.
When transporting or parking the machine, loosen the
wing nut (1) and lower the antenna (2) to prevent
damage.
2
1
5
4
3
1
2
4
3
1
2
