4-8
MACHINE OPERATION
SY60C Excavator OMM
4.
Route the drain hose (2) into a suitable container.
5.
Open the drain valve (3) and drain the water and
sediment.
6.
When only clean fuel flows through the drain valve,
close and tighten the valve.
7.
Start the engine and check for leaks.
Check Hydraulic Oil Level
0002926
Figure 4-8
NOTE:
The work equipment should be positioned as
shown above before checking hydraulic oil level.
1.
Prepare the machine for maintenance. See
“Maintenance Safety” on page 2-5.
2.
Open the engine hood. See “Opening the Engine
Hood” on page 5-14.
3.
Open the right rear access door. See “Left and Right
Rear Access Doors” on page 5-13.
0003006
Figure 4-9
4.
Check the hydraulic oil level in the hydraulic oil tank
through the sight gauge (1). The hydraulic oil level
should be between the H (2) and L (3) marks.
5.
If the level is below the L mark, add hydraulic oil. See
“Add Hydraulic Oil” on page 5-29.
Check and Fill the Windshield Washer Fluid
1.
Prepare the machine for service. See “Maintenance
Safety” on page 2-5.
0002962
Figure 4-10
NOTE:
Keep dust and dirt out of the windshield washer
tank when adding window washer fluid.
2.
Open the engine hood. See “Opening the Engine
Hood” on page 5-14.
3.
Open the left rear access door. See “Left and Right
Rear Access Doors” on page 5-13.
4.
Check the fluid level in the windshield washer tank
(1).
5.
If necessary, remove filler cap and add windshield
washer fluid. See “Windshield Washer Fluid” on
page 5-7.
6.
Install the filler cap after filling.
2
3
1
1
