17
§
§
3
3
.
.
1
1
4
4
S
S
e
e
t
t
t
t
i
i
n
n
g
g
B
B
a
a
t
t
t
t
e
e
r
r
y
y
T
T
y
y
p
p
e
e
①
Check that the UPS is in the following condition.
②
Press and hold
for 3 or 4 seconds. Then release it when two beeps are heard.
③
Quickly press
(within 3 seconds) several times to set the 5 LEDs surrounded by in the figure
below to a blinking pattern such as the one in the figure.
④
Quickly press
(within 3 seconds) several times to switch to the setting value LED blinking pattern
to select for the 4 LEDs surrounded by
in the figure below.
⑤
Perform the steps 3 to 5 in §3.16 "Resetting Battery Information”.
LEDs that blink when the “10 years” setting is selected.
Setting
Setting LED
Description
5 years
●
○
○
○
5 years lifetime type
10 years
○
●
○
○
10 years lifetime type
3 years
●
●
○
○
3 years lifetime type
Select the battery type according to the type of the mounted
battery. When the 5 years lifetime type battery is mounted, “5
years” must be selected. Even if “10 years” is selected, the
actual battery service life cannot be extended to 10 years.
Default
setting
The blinking pattern changes each time you press
or
.
If you miss the LED blinking pattern you want to select, continue pressing
the button repeatedly until the LED blinking pattern is redisplayed.
Tip
Set the battery type. Set this when you replace
the battery or connect an external battery.
Proceed to §3.16 “Resetting Battery Information”
⇒
page 19
After changing the setting, perform the steps 3 to 5 in §3.16 “Resetting
Battery Information”. This setting does not take effect until the battery
information is reset. Do not perform the procedure above except in the
battery replacement.
Note
MAIN SW on the back panel set to “ON” *1
The “Green INV.ON/STAND BY” and
the “Green OUTPUT are not blinking. *2
*1. Operation is possible regardless of whether
is ON or OFF.
*2. If these LEDs are blinking, Forced Bypass switch
may be set to “Bypass”. Set this switch to “Inverter”,
and restart the UPS.
Tip
The UPS switches to the user setting mode.
Buzzer sounds : 2 beeps
：
Either BATT.LOW or 25
blinks,
or both
BATT.LOW and 25
blink.
：
INPUT blinks.
：
LED is off.
：
LED is blinking.
Press
Press
Hold for 3 or 4 sec.
until 2 beeps.
