Sanyo 1113 27004, Service Manual

-7-

F3JEV

B1 POWER SUPPLY ADJUSTMENT
1. Set VR641 to be mechanically centre before

pressing the mains ON/OFF switch.

2. Tune the receiver to a PAL circular pattern.
3. Set the brightness and contrast controls to

normal.

4. Connect a digital V-meter to test point "TP-B".
5. Using VR641, adjust the voltage to 130 ± 0.5V.

AFT ADJUSTMENT
1. Tune the receiver to the clearest station. 
2. Using T141, adjust the AFT to obtain the best
picture.

AGC ADJUSTMENT
NOTE: 

Do not attempt this adjustment with a

weak signal.
1. Tune the receiver to the clearest station.

2. Set AGC VR(VR131) in direction which causes

snow noise just to appear, then in the opposite
direction until the snow noise just disappears.

GREY SCALE ADJUSTMENT

[SCREEN VR ADJUSTMENT]
1. Tune the receiver to the white pattern.
2. Set the brightness and contrast controls to

normal.

3. Set VR2602and VR2612  to their mechanical

centres.

4. Turn VR2601, VR2611 and VR2621 fully

counter-clockwise (anti-clockwise).

5. Set the TV into service mode by pressing the

Function button 

on the Remote control and

the Prog + 

on the TV front panel. Press the

Function button 

on the Remote control until

“SCREEN” is highlighted. This sets up a
horizontal scanning  line.

6. Set screen VR so that one colour is just visible.
[BIAS VR ADJUSTMENT]
7. By using VR2601, VR2611 or VR2621, adjust

the line until it becomes white.

8. Set screen mode  OFF, by pressing the Recall

button 

on the Remote control.

[DRIVE VR ADJUSTMENT]
9. Using VR2602 and VR2612, adjust white

balance.

HIGH VOLTAGE & WIDTH ADJUSTMENT
[HIGH VOLTAGE ADJUSTMENT]
1. Tune the receiver to the circular pattern.
2. Set the brightness and contrast controls to

maximum.

3. Connect a digital V-meter to both terminals of

R224, and a high voltage meter to the CRT
anode.

4. Confirm high voltage to be 25.0 ± 1 KV at

beam current 1.1mA, and less than 28.0 KV at
0 beam current.

[H-WIDTH ADJUSTMENT]
5. Adjust VR462 to obtain proper H- width .
6. Reconfirm high voltage.

H-CENTRE ADJUSTMENT
1. Tune the receiver to a circular pattern.
2. Adjust H-centre by using VR361.

V-CENTRE ADJUSTMENT
1. Tune the receiver to a circular pattern.
2. Adjust V-centre by using SW501.

V-SIZE ADJUSTMENT
1. Tune the receiver to a circular pattern.
2. Adjust V-size by using VR501.

FOCUS ADJUSTMENT
By using FOCUS VR, adjust focus control for
good scanning lines.

F

P

F