Sanyo 111320506, Original Manual

-8-

Service manual-EC5 chassis

B1 POWER SUPPLY ADJUSTMENT
1. Set VR641 to be mechanical centre before pressing

the main switch.

2. Tune the receiver to PAL circular pattern.
3. Set brightness and contrast controls to normal.

4. Connect digital V-meter to the right side terminal of

R638.

5. By using VR631, adjust voltage to 150 ± 0.5 V.

AFT ADJUSTMENT
1. Tune the receiver to the clearest station.
2. By using T141, adjust AFT to obtain the best  picture.

AGC ADJUSTMENT
NOTE:

Do not attempt this adjustment with weak

signal.
1. Tune the receiver to the clearest station.

2. Set AGC VR(VR131) in direction which causes snow

noise to appear, then in the opposite direction until
snow noise just disappears.

GREY SCALE ADJUSTMENT

[SCREEN VR ADJUSTMENT]
1. Tune the receiver to the white pattern.
2. Set brightness and contrast controls to normal.
3. Set VR702 and VR712  to be mechanical centre.
4. Turn VR701, VR711 and VR721 fully counter-clock-

wise.

5. Connect a short lead between pin30 of IC801 and

GND to enter the service mode.

6. Set screen VR for one colour to be just visible.
[BIAS VR ADJUSTMENT]
7. By using VR701, VR711 or VR721, adjust line to be

white.

8. Disconnect a short lead.

[DRIVE VR ADJUSTMENT]
9. By using VR701 and VR711, adjust white balance.

HIGH VOLTAGE & WIDTH ADJUSTMENT
[HIGH VOLTAGE ADJUSTMENT]
1. Tune the receiver to circular pattern.
2. Set brightness and contrast controls to maximum.
3. Connect digital V-meter to both terminals of R224, and

high voltage meter to CRT anode.

4. Confirm high voltage to be 26.0 ± 1 KV at beam cur-

rent 1.3mA, and less than 29.0 KV at 0 beam current.

[H-WIDTH ADJUSTMENT]
5. Adjust VR461 to obtain proper H- width.
6. Reconfirm high voltage.

H-CENTRE ADJUSTMENT
1. Tune the receiver to circular pattern.
2. Adjust H-centre by using VR361.

V-CENTRE ADJUSTMENT
1. Tune the receiver to circular pattern.
2. Adjust V-centre by using SW501.

V-SIZE ADJUSTMENT
1. Tune the receiver to circular pattern.
2. Adjust V-size by using VR501.

FOCUS ADJUSTMENT
By using FOCUS VR, adjust focus control for the best
scanning lines.