Sanyo ASW U1100T, Service Manual

- 13 - 

CAUTION:

1.  Do not bend the lever of safety device when opening the Top Plate, otherwise operating 

angle of device will be out of specification. 

2.  As wires for connecting control parts are placed underneath the Top Plate, after removing 

the  Top  Plate  and  reconnecting  wires, make  sure  that the  wires are  not pinched  or stuck 
between Frame and the Top Plate.  

Replacement of Top Plate

(1)  Follow the steps (1) to (2) of  Replacing Font Panel .  
(2)  Follow the steps (2) to (4) of  Replacing Control Plate . 
(3)  Follow the steps (1) to (3) of  Removing Back Plate . 
(4)  Take out 4 screws that are holding Top Plate and Frame. 
(5)  Tilt the Top Plate backward during lifting it up. 
(6)  Once the Top Plate is removed, the Response Switch, Water Pump can be replaced. 
(7)  Reverse the order of the steps above to put the unit back.      

Removing Washer Lid

(1)  Open the washer lid. 
(2)  Remove  the  washer  lid  during  pushing  the  shaft  center  of  hinge  at  left,  using  a  plate  blade   

screwdriver. 

(3)  Move the top lid to the left side and lift it up. 
(4)  Remove the Hinge Spring from the Washer Lid. 
(5)  Follow the above steps reversely when you want to assemble them again.    

Removing Magnetic Valve

(1)  Follow the steps (1) to (3) of  Replacing Back Plate . 
(2)  Move Soap Box Ass y. 
(3)  Remove two screws that are holding Pour Inlet Ass y and Top Plate. 
(4)  With a screwdriver (-), carefully remove the edges on both ends (left and right) of the Pour Inlet Ass y 

and lift it up. Be careful not to scratch the Top Plate. 

(5)  Remove three screws holding Magnetic Valve and Pour Inlet Ass y. 
(6)  Pull Magnetic Valve from Pour Inlet Ass y. 
(7)  Follow the above steps reversely when you want to assemble them again.  

Replacement of Air Trap Hose

(1)  Remove Top Plate. 
(2)  Pull out Air Trap Hose after making sure of no water in Outer Tub. If water remains in Outer Tub, pull 

Connection Wire of drain valve to drain by hand. 

(3)  Wipe the surface which the hose will connect to with thinner liquid. 
(4)  Apply vinyl chloride type adhesive to the surface of pipe and insert new hose into the pipe completely 

Notice : Do not cover the end of pipe by making a film of glue during glue application. 

(5)  Fit Hose Band at the middle of the pipe.  

Handle of the washer lid

The hooks of the washer lid will be broken if you remove the handle.        

When  the  handle  is  damaged,  the  Washer  Lid  Assembly  containing  the  handle  must  be  

replaced. 

Wipe with thinner liquid

Pipe for connection ( Outer tub)

Apply vinyl chloride type adhesive

Air Trap Hose

Hose Band