Sanyo ASW U1100T, Service Manual

- 6 -  

7.  Operation of fully Automatic Washing program 

NORMAL, HEAVY DUTY, CUSTOM, SOAK 

Course:

Turn on the power switch (ON/ OFF) 
Load the laundry into the washer 
Press the ONE TOUCH SELECT to select the washing course 
Press the START/ PAUSE button                           

The  washer  begins  rotating  the  Pulsator  right  then  left  two  times 
to  check  the  volume  of  the  laundry  and  select  the  most  suitable 
water level. 
Water is supplied to the lowest water level LOW2. 

The  Pulsator  rotates  right  and  left  in  about  40 ,  in  that  time 
sensor  will  determine  type  of  fabric  and  select  the  most  suitable 
program,  such  as:  Spinning  time,  Washing  time,  Rinsing  mode, 
water flow

Water is supplied to the selected water level. 

In  Soak course, the laundry is soaked for 45 minutes. During the 
soaking,  Pulsator  will  rotate  intermittently  5  minutes  per  cycle  to 
stir the laundry. 

Within  40  seconds  from  washing  process,  Pulsator  rotates  to 
create flow water to confirm water level. 

40 seconds after starting washing, Pulsator stops in 4 seconds to 
check the water level, if the water level is lower, the program will 
automatically  supply  the  water  until  the  selected  water  level  is 
reached 
1  minute  after  starting  washing  process,  sensor  will  receive  the 
signals  from  revolution  of  laundry.  Responding  to  the  revolution 
of  laundry,  microchip  will  determine  the  most  suitable  water 
flows. 
1  before  completion  of  washing  process,  Pulsator  will  rotate  to 
create laundry disentanglement flow water. 

After  water  level  reaches  reset  point,  draining  course  continues 
for 1 40 . 

In the first spinning, washer carries out 1 10  ON intermittent spin 
dry cycle. 
Before  completion  of  spinning,  electrical  continuity  of  motor 
breaks  off  and  motor  rotates  continuously  by  inertia.  The  Brake 
Ass y activates while Spin Tub revolution speed is slowing down. 
During Spinning: If the clothes clump on one side or the Spin Tub 
becomes  unbalanced,  the  microchip  will  detect  the  unbalance 
condition and automatically proceed the following corrective. 
Water is supplied to the selected water level. 

Water  save  rinse:  Water  is  supplied  to  the  selected  water  level 
responding  to  the  wash  load,  Pulsator  rotates  and  water 
supplying is stopped. 
Overflow rinse: After water is supplied to the selected water level, 
Pulsator rotates and water is continuously supplied. 

PULSATOR ROTATES

WATER IS SUPPLIED

PULSATOR ROTATES

WATER IS SUPPLIED

SOAK 

WASH

WATER IS SUPPLIED 

WASH

DRAIN

SPIN

WATER IS SUPPLIED

RINSE

After 40

RINSE

WASH