-11-
F7YLV
OPTION SETTING
[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the option data of TV set and service adjustments data for each circuit, therefore,
when the memory IC is replaced, it should be programmed with the following setting and “SERVICE ADJUSTMENT”
on next page.
To enter to the Option Mode
+ Press and hold the “RECALL”button on the remote control and “PROG.+” button on the front panel of the TV. The
option window will appear on the screen.
To set the option mode
+ Highlight the desired option item by using the UP or DOWNbutton .
+ To switch the option mode, use the Volume - (LEFT) or (RIGHT) button.
+ The data which is set in the option mode is stored into the memory IC automatically.
Following table shows the available option items and default setting mode.
Exit from the Service Mode
+ Press the RECALL button.
Option Mode
Mode
Note
ON-TIMER
ON or OFF
Default “ON”
SORT MODE
ATS EURO PLUS
Depends upon destination
or AUTO TUNE
or AUTO TUNE/SORT
PLUG & PLAY
ON or OFF
Default “ON”
WELCOME TEXT
ON or OFF
Display message when first set up, default “ON”
CODE TEST
OFF or ON
For factory use, default “OFF”
WSS
ON or OFF
Wide Screen Signaling available, default “ON”
ON-TIMER
ON
SORT MODE
ATS EURO PLUS
PLUG & PLAY
ON
WELCOME TEXT
ON
CODE TEST
OFF
WSS
ON
OPTION
ADJUST : EXIT : RECALL
Summary of Contents for CE32WH3-F
Page 35: ... 35 F7YLV 17 20 21 5 19 2 16 15 18 4 11 ...
Page 68: ...MAIN BOARD CIRCUIT SIDE MAIN BOARD COMPONENT SIDE ...
Page 79: ......