-15-
F7YLV
By using FOCUS VR, adjust focus control to obtain
sharpest picture.
SCREEN ADJUSTMENT
1. Select AV1 mode with no signal input.
2. Enter to the service mode and select mode
“REGULAR”, item “REGULAR 4SCR”.
3. Turn the screen VR to set data value to be “11”.
GREY SCALE ADJUSTMENT
1. Receive white raster pattern.
2. Enter to the service mode and select mode
“REGULAR”, item “REGULAR 5SRY”.
3. Select data value by using program up or down key,
and press the or - key to obtain the proper
white balance.
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode
“REGULAR”, item “REGULAR 8OSD”. The OSD test
bar will appear on the top of screen.
3. Press the or - key to adjust the proper OSD
positioning.
VERTICAL CENTRING ADJUSTMENT
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 6.P V-L”.
3. Press the or - key to adjust vertical centre.
VERTICAL HEIGHT ADJUSTMENT
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 4.P V-WA.
3. Press the or - key to adjust proper vertical
height.
HORIZONTAL CENTRING ADJUSTMENT
1. Receive circular pattern and set screen mode to
“FULL”.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 8.P H-P”.
3. Press the or - key to adjust horizontal centre.
HORIZONTAL WIDTH ADJUSTMENT
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 9.P H-W”.
3. Press the or - key to adjust horizontal centre.
PCC-1 ADJUSTMENT(LINEARITY)
1. Receive cross hatch pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 11.P PCC”.
3. Press the or - key to adjust vertical linearity.
PCC-2 ADJUSTMENT(TILT)
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Enter to the service mode and select mode “WIDE”,
item “WIDE 16.P-TRP”.
3. Press the or - key to adjust the tilting of
vertical lines.
1. Receive circular pattern and set screen mode to
“FULL” with R/C wide button.
2. Connect high-voltage meter to the anode of CRT and
GND.
3. Confirm that voltage is 30.5±1.0kV for 32” model.
HIGH-VOLTAGE CONFIRMATION
PCC ADJUSTMENT
HORIZONTAL ADJUSTMENT
VERTICAL ADJUSTMENT
OSD CENTRING ADJUSTMENT
GREY SCALE ADJUSTMENT
FOCUS ADJUSTMENT
Summary of Contents for CE32WH3-F
Page 35: ... 35 F7YLV 17 20 21 5 19 2 16 15 18 4 11 ...
Page 68: ...MAIN BOARD CIRCUIT SIDE MAIN BOARD COMPONENT SIDE ...
Page 79: ......