20
7. Use the digit keys to enter the desired telephone number. If you make a
mistake, press
CH/DEL
to delete previous digits one by one, then enter the
correct digits. If you wish to add a pause, press
PAUSE
two times at the
desired location. Be sure to press it twice, or you will enter a # (number sign)
and not a pause. Each pause counts as 1 digit in the dialing sequence. Or
you can store redial number in the directory by pressing
REDIAL
(Note: If the
redial number is longer than 24 digits, it cannot be stored into the memory.).
8. Press
MEM
again to store the number to memory. If you are replacing a
number, “REPLACE MEMO?” shows on screen. Press
MEM
again to confirm,
or press *
TONE/EXIT
to return to standby mode.
To view your directory, press
MEM
and use
CID/VOL
or
or the number
(0-9) to scroll.
Replacing a directory entry with a Caller ID entry
Use the same procedure as for
storing Caller ID entries in the directory
Changing a stored number
Use the same procedure as for
storing a number in the directory
Making calls from the directory
1. Make sure the phone is ON by pressing
TALK
.
2. Press
MEM
.
3. Press the number
(0 - 9)
for the desired memory location. The number dials
automatically.
Or:
1. Make sure the phone is OFF (not in TALK mode).
2. Press
MEM
.
3. Press the number (0-9) or use
CID/VOL
or
to select the desired
number.
4. Press
TALK
, the number will be dialed automatically.
Reviewing and deleting directory contents
1. Make sure the phone is OFF (not in TALK mode).
2. Press
MEM
.
3. Use
CID/VOL
or
to scroll through the directory until the desired name/
DIRECTORY
