5
Need help?
Visit our Web site at
www.sanyoctv.com
or Call
1-800-877-5032
2
Connect Signal to the DTV’s Integrated
Analog / Digital 75 ohm Antenna Input
terminal.
GETTING STARTED
(REQUIRED INITIAL SETUP)
1
Install batteries in remote control (2AAA,
not included).
3
Plug in AC power cord
(120V AC, 60 Hz).
5
Perform “All Channel Search.” The All
Channel Search will search for off-air digital
and analog channels, and analog cable chan-
nels. The DTV can receive cable or off-air
channels, but not at the same time.
If after
two searches
the DTV still
fails to detect
any channels,
the DTV will
tune to Video1.
PRECAUTIONS
To ensure safe operation, please observe
the following precautions:
R
eplace both batteries at the same time. Do
not use a new battery with a used battery.
Risk of explosion, if battery is replaced by
an incorrect type.
Do not expose the Remote Control Unit to
moisture or
heat.
RF ANTENNA
CABLE
OR
CABLE BOX OR SATELLITE BOX
OR
DTV ANALOG/
DIGITAL
ANTENNA IN
Match the “+” and “–” signs
on the batteries with marks
inside the remote control.
To 120 V AC outlet.
INITIAL ON-SCREEN
ALL CHANNEL SEARCH
4
Press the
POWER
key. (Follow on-screen
instructions.)
Note: If
EXIT
is pressed,
the DTV will skip Channel
Search and tune to Video1
without storing any chan-
nels in the Channel Map
databases.
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and /or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note: You must search for ClearQAM channels using
the “Digital Cable Search” menu option.
OR
3. The output from a VCR or cable box.
Digital signals can also be received through the
HDMI jacks.
Digital signals from a Set-top (STB) Box should be
received through the Video 1, 2, or 3, or HDMI Input1
or 2 jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
ANALOG CHANNELS
DIGITAL CHANNELS
