– 4 –
ON-SCREEN SERVICE MENU
Table 1. ON-SCREEN SERVICE MENU
When IC801 (EEPROM) is replaced, check the bus data to confirm they are the same as below. See page 3 for
On-Screen Service Menu access and adjustments.
PROGRAM CODES
The microprocessor used in this model is a multi-purpose type and is used in several different models. To ensure
proper operation and the correct features for your particular model, the program codes must be correct.
Note 1. Option Data 1 (No. 2 OP1) should be hexadecimal 00.
See 2 above. If this program code is wrong the TV will not operate properly.
Note 2. Option Data 2 (No. 3 OP2) should be hexadecimal 1B.
See 3 above. If this program code is wrong the TV will not operate properly.
NOTES: Option 1 and Option 2 data is initial and can be set according to adjusment information.
Option 2 Data (Display Panel)
No.
Title
Initial Data
Note
1A0
MUTE
A0h
Audio mute at Power ON
086
VOL
30h
Volume setup inspection
087
OP1
00h
Option 1 Data (HDMI)
088
OP2
1Bh
Option 2 Data (Display Panel)
101
1R00
00h
ROM Correction Data
102
1R01
00h
ROM Correction Data
↓
↓
↓
↓
197
2R47
00h
ROM Correction Data
198
2R48
00h
ROM Correction Data
Summary of Contents for DP50741
Page 33: ... 29 IC1640 IC5730 DC to DC Converter IC BLOCK DIAGRAMS CONT IC801 EEPROM ...
Page 35: ... 31 IC5500 Block Diagram IC BLOCK DIAGRAMS CONT IC6200 Low output Amplifier ...
Page 36: ... 32 IC8500 USB Protection IC5700 DDR Double Data Rate SDRAM ...