Sanyo ECD-T1580DV, Owner'S Manual

25

OPERATION

everse, 

 : Rapid advance

Note:  The FOLDER cannot be selected
during playing.  It can be selected after

 (Stop) button pressed.

 :  Rapid r

During playback, use 

 or    to skip an

item ahead or back.

same song over and over again.

FOLDER REP:
Play all songs in the current directory in
sequence, over and over again.

When select PLAY MODE, press     /   
to change between the following mode:

REP-ONE

FOLDER

FOLDER REP

DISC

DISC REP

RANDOM

PROGRAM PXXX

button repeatedly can select three kinds 
of repeat play modes.

REP-ONE:
Play the 

FOLDER:

Play all songs in the current directory 
once.

SINGLE

DISC SCAN

SHUFFLE ON

Switching to radio mode

Press 

MODE 

button on remote

control to select radio mode.
In radio mode, the following
information will appear on the display.

Selecting the frequency band

Press 

BAND 

on remote control to

select desired band. The reception
band will change in the following
order:

FM1 98.1 MHz

MONO 

40

M1

87.50

BASS

-2

M2

90.10

TREBLE

-2

M3

98.10

BALANCE

L-R

M4 106.10

FADER

F-R

M5 108.00

LOUD

OFF

M6

87.50

EQ

POP

RADIO OPERATION

FM1

FM2 

FM3

AM1

AM2

VOLUME

Selecting station

During radio mode, press CH    button
on remote control to increase
frequency or CH    button on remote
control to decrease frequency by one
step of channel spacing. Hold the
button longer for fast tuning. The
frequency is updated correspondingly
on display.

Setting memory

Press 

RADIO PRESET 

buttons (1~6)

on remote control to preset stations
at radio mode. With this system, a
total of 30 stations can be stored in
the memory of six buttons. Each
band stores up to six preset stations.
The stations might be FM1, FM2,
FM3, AM1 and AM2 band.
The operation is as below:
-   Store in Memory
    Press and hold desired
    memory location button for
    several seconds. The current
    listening station will be stored
    into the number button.
-   Retrieve a Preset Station
    Press any one of the 

RADIO

    PRESET 

buttons (1~6) on

    remote control to retrieve a
    station which had been stored
    in the memory in advance the
    chosen number is shown on
    display.

Automatic memory storing &
program scanning

-   Automatic memory storing
    Press 

GOTO (AS/PS) 

button

    on remote control for several
    seconds, the radio searches
    from the current frequency and
    checks the signal strength until
    one cycle search is finished.
    And then 6 strongest stations
    are stored into the
    corresponding preset number
    button.
-   Program scanning
    Press 

GOTO (AS/PS) 

button

    on remote control shortly to
    scan preset station.