Sanyo FWSA205E, Owner'S Manual

2    

EN

•

Connect the equipment into an outlet 
on a circuit different from that to 
which the receiver is connected.

•

Consult the dealer or an experienced 
radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC 
radiation exposure limits set forth for an 
uncontrolled environment. This equipment 
should be installed and operated with a 
minimum distance of 20cm between the 
radiator and your body.
This transmitter must not be co-located or
operated in conjunction with any other 
antenna or transmitter.

FCC Warning: 

Any changes or 

modifications made to this device that 

are not expressly approved by Funai 
Corporation, Inc. may void the user’s
authority to operate the equipment.
Model number:  FWSB415E
Trade Name: SANYO

Canada:

CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from 
the routine evaluation limits in section 
2.5 of RSS 102 and compliance with 
RSS-102 RF exposure, users can obtain 
Canadian information on RF exposure and 
compliance.
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation 
is subject to the following Two conditions: 
(1) this device may not cause harmful 
interference, and
(2) this device must accept any 
interference received, including 
interference that may cause undesired 
operation.

1 Notice

This section contains the legal and 
trademark notices.

1.1 Notice of 

Compliance

The device complies with the FCC rules, 
Part 15. Operation is subject to the 
following two condition:

a 

This device may not cause harmful

interference, and

b 

This device must accept any 
interference received, including 
interference that may  cause 
undesired operation.

FCC rules

This equipment has been tested and found 
to comply with the limits for a Class B 
digital device, pursuant to part 15 of the 
FCC Rules.These limits are designed to 
provide reasonable protection against 
harmful interference in a residential 
installation. This equipment generates,
uses and can radiate radio frequency 
energy and, if not installed and used in 
accordance with the instruction manual, 
may cause harmful interference to radio 
communications. However, there is no 
guarantee that interference will not occur 
in a particular installation. If this equipment 
does cause harmful
interference to radio or television 
reception,which can be determined by 
turning the equipment off and on, the 
user is encouraged to try to correct 
the interference by one or more of the 
following measures:

•

Relocate the receiving antenna.

•

Increase the separation between 
equipment and receiver.