- 21 -
HEC-DR5000
(GENERAL)
Replacement Procedure
(1) Replacement of PCBs (main)
& (power)
1, Take off four thread caps on an arm rest
(left). Photo-1
2, Remove four set screws on the elbow rest
and take off the arm rest (left). Photo-1
3, Lift up a foot rest and insert a screwdriver
and so forth into a link to fix the link.
Photo-2
4, Remove four cover (under front) set screws
and take off the cover (under front).
Photo-2
5, Remove two cover (PCB) set screws and take
off latches of ribs at the rear of the cover.
Photo-3
6, Disconnect connectors connected to the
PCB (power). Photo-4
7, Unfix seven stoppers (PCB) and take off the
PCB (power). Photo-4
8, Remove three stay (PCB) set screws and
take off the stay (PCB). Photo-4
* There is a set screw around under a reclining
motor at the left side.
9, Disconnect the connectors connected to the
PCB (main). Photo-4
10, Unfix nine stoppers (PCB) from the bottom
side of the massager and take off the
PCB (main). Photo-4
Arm rest set screws
Thread caps
Photo-1
Cover set screws
Cover (under front)
Driver, etc
Photo-2
Cover (PCB)
Cover (PCB) set screws
Photo-3
PCB (power)
Stoppers
PCB (main)
Stay (PCB) set screws
Photo-4
Arm rest (left)
