Sanyo HEC-FX1, Service Manual

- 9 -

HEC-FX1/RX1

Replacement Procedure

(1) Replacement of Arm Rest Assembly
      and Cover (Arm Rest Lower) Right

1, Remove two arm rest set screws on the back
     of main body.                                      Photo-1

5, Remove two arm rest set screws, disconnect
     the connector between the arm rest (right)
     and main body and take off the arm rest
     (right).                                                  Photo-3

      * In case of removing the arm rest set
          screws, pay attention to the arm rest
          falling down from the main body.

2, Lay down the main body with the back rest
     underneath,  a foot rest becomes the top. 
                                                                 Photo-2
3, Lift up the foot rest and bind the reclining
     motor (foot rest) and the frame (foot rest)
     with a string tightly.                          Photo-2
4, Remove two arm rest set screws and take
     off the arm rest (left).                         Photo-2

      * In case of removing the arm rest set
          screws, pay attention to the arm rest
          falling down from the main body.

6, Take off three ornament (cover screw).
                                                                  Photo-2
7, Remove three cover (arm rest lower) right
     set screws and take off the cover (arm rest
     lower) right.                                        Photo-4

Photo-1

Arm rest set screws 

Cover (back cover)

Cover set screws 

Cover set screws 

Arm rest (left)

Arm rest (right)

Arm rest

set screws 

Arm rest

Bind reclining motor and

frame with a string

Photo-2

Photo-4

Cover (arm rest lower) right

Cover set screws 

Photo-3

Connector

Arm rest (right)

Frame (foot rest)

Cover (front upper)

Cover (front lower)

Reclining motor

(foot rest)

Ornament (cover screw)