PLV-HD2000 Basic Serial Command Functional Specifications
14/24
6.34 FULL LAMP MODE SET Command
COMMAND “C70”
[CR]
Detail
Set all lamps to ON
When switching from full-lamp mode (with 4 lamps ON) to 2-lamp mode, then to
full-lamp again, or switching from 2-lamp to full-lamp then to 2-lamp again, allow
about 90 seconds of preparation time for lamp lighting.
Acceptable [ACK]
[CR]
Response
Unacceptable “?”
[CR]
6.35 HALF LAMP MODE 1 SET Command
COMMAND
“C71” [CR]
Detail
Set to HALF LAMP Mode (2-lamp mode)
Lamps No.1 & No.4 are turned on.
When HALF LAMP Mode is set, the projector automatically selects the lamps
which are turned on, but with this command, the lamps No1 & No.4 are first
chosen. This is used to adjust the correction level of uneven color.
When switching from all lamps to 2 lamps, then to all lamps again, or switching
from 2 lamps to all lamps, then to 2 lamps again, allow about 90 seconds of
preparation time for lamp lighting.
Acceptable [ACK]
[CR]
Response
Unacceptable “?”
[CR]
6.36 HALF LAMP MODE 2 SET Command
COMMAND
“C72” [CR]
Detail
Set to HALF LAMP Mode (2-lamp mode)
Lamps No.2 & No.3 are set.
Usually when HALF LAMP Mode is set, the projector automatically chooses
lamps, but with this command, the lamps No2 & No.3 are first chosen.
When switching from all lamps to 2 lamps, then to all lamps again, or switching
from 2 lamps to all lamps, then to 2 lamps again, it is unable to switch for 90
seconds for the Lamp preparation.
Acceptable [ACK]
[CR]
Response
Unacceptable “?”
[CR]
6.37 AUTO PC ADJ. Command
COMMAND
“C89” [CR]
Detail
Execute Auto PC Adj. function
This command works the same way as “AUTO PC” button of the remote control.
Auto PC Adj. operation is stoped if a command is issued while the operation is
ongoing.
Acceptable [ACK]
[CR]
Response
Unacceptable “?”
[CR]
