6
INSTALLATION
WARNING
Always disconnect a power supply plug and turn OFF the power switch of equipment before installing this
board to the equipment to avoid an electric shock or injury by accidental contact with electric component
inside the equipment.
Never disassemble, repair, or modify the unit yourself. Any such work carried out by an unauthorized
person may result in fire or injury due to a malfunction.
Install MCO-420MA to its intended location in the equipment from which analog data is acquired by
following the procedure below.
Installation except for MCO-80IC
1.
By removing two screws, remove the cover on the
installation location. (Fig. 1)
2.
Insert the connector of an enclosed connecting
cable into the location A, B and C. (Fig. 2)
A.
Connector on the back of the MCO-420MA.
B.
Connector CN7 on a main board.
C.
Pin TP2 on a main board for 24V power supply.
3.
Fix MCO-420MA to its intended location by using
enclosed four screws. (Fig. 3)
Cover
Fig. 1
Fig. 3
MCO-420MA
Connecting
cable
C
Main board
Fig. 2
Example: MCO-20AIC
MCO-420MA
A
B
