24
Turning On the Projector
Connect the projector’s AC power cord into an AC
outlet and turn on the MAIN ON/OFF Switch. The
LAMP indicator lights red and the POWER indicator
lights green.
Press the ON/STAND-BY button on the side control
or on the remote control. The LAMP indicator
dims red and the cooling fans start to operate. The
preparation display appears on the screen and the
countdown starts.
2
3
1
16
The preparation display will disappear after 20
seconds.
4
After the countdown, the input source that was
selected the last time and the Lamp status icon
(see page 65) appear on the screen.
If the projector is locked with a PIN code, PIN code
Input Dialog Box will appear. Enter the PIN code as
instructed below.
Selected Input Source and Lamp control
Complete peripheral connections (with a computer,
VCR, etc.) before turning on the projector.
what is PIN code?
PIN (Personal Identification Number) code is a security
code that allows the person who knows it to operate the
projector. Setting a PIN code prevents unauthorized use
of the projector.
A PIN code consists of a four-digit number. Refer to the
PIN code lock function in the Setting Menu on pages 58-
59 for locking operation of the projector with your PIN
code.
PIN code Input Dialog Box
Enter a PIN code
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Take special care in setting a
new PIN code; write down the number in a column
on page 86 of this manual and keep it on hand.
Should the PIN code be missing or forgotten,
consult your dealer or service center.
After the OK icon
disappears, you can
operate the projector.
Lamp
status
See page 65 for the Lamp mode status
✔
Note:
• The Lamp replacement icon and the Filter warning
icon may appear on the screen depending on the
usage state of the projector.
• If the filter cartridge is not installed in the projector,
the Warning Filter indicator does not light up and
the Filter warning icon does not appear.
Use the Point
ed
buttons on the side control or on the
remote control to enter a number. Press the Point
8
button to fix the number and move the red frame pointer
to the next box. The number changes to “
✳
.” Repeat
this step to complete entering a four-digit number. After
entering the four-digit number, move the pointer to “Set.”
Press the SELECT button so that you can start to operate
the projector.
If you fixed an incorrect number, use the Point
7
button
to move the pointer to the number you want to correct,
and then enter the correct number.
If you entered an incorrect PIN code, “PIN code” and the
number (
✳✳✳✳
) will turn red for a moment. Enter the
correct PIN code all over again.
✔
Note:
• When the Logo select function is set to “Off,” the
logo will not be shown on the screen (p.54).
• When the “Countdown off” or “Off” is selected
in the Display function, the countdown will not be
shown on the screen (p.49).
• During the countdown period, all operations
except for Zoom, Focus, and Lens-shift functions
are invalid. If the projector has been locked with a
PIN code, however, Zoom, Focus, and Lens-shift
functions are also invalid.
• If you press the ON/STAND-BY button on the side
control or the remote control during the countdown
period, you can skip the countdown and go to the
normal operations.
• If the PIN code number is not entered within three
minutes after the PIN code dialog box appeared,
the projector will be turned off automatically.
• The “1234” is set as the initial PIN code at the
factory.
Basic Operation
