PLC-ET30L Expand Serial Command Functional Specifications
18/62
8.4.8 CF_COLTEMP Command
Command
“CF_COLTEMP_%1” [CR]
%1
“000” ------------------------------ Xlow
“001”------------------------------- Low
“002”------------------------------- Mid
“003”------------------------------- High
Details
Set Color Temperature (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.4.9 CF_NZRED Command
Command
“CF_NZRED_%1” [CR]
%1
“OFF” ---------------- Cancel Noise Reduction
“L1” ------------------- Set Noise Reduction L1
“L2” ------------------- Set Noise Reduction L2
“UP” ------------------ Toggle between ON and OFF. (OFF
→
L1
→
L2
→
OFF...)
“DN” ------------------ Toggle between ON and OFF. (OFF
→
L2
→
L1
→
OFF...)
Details
Set Noise Reduction level (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It returns to the original setting in Suspend mode as well.)
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.4.10 CF_PROGV Command
Command
“CF_PROGV_%1” [CR]
%1
“OFF” -------------- Set Progressive scan to OFF.
“L1” ----------------- Set Progressive scan to L1(for movie image).
“L2” ----------------- Set Progressive scan to L2(for still image).
“FILM” ------------- Set Progressive scan to Film.
“UP” ---------------- Switch setting forward direction (OFF
→
L1
→
L2
→
FILM
→
OFF)
“DN” ---------------- Switch setting backward direction (OFF
→
FILM
→
L2
→
L1
→
OFF)
Details
Set Progressive scan mode. (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Response
Acceptable
“000” [CR]
Unacceptable
“Error Code” [CR]
8.4.11 CF_IMAGE Command
Command
“CF_IMAGE_%1” [CR]
%1
“DYNAMIC” ---Dynamic (Fixed value to enable projection with a sharp, powerful
picture tone)
“STAND” -------Standard(Image adjust value is set to factory default for Still Image)
“REAL---------- Real (Fixed value to display graphic image with natural tone)
“CINEMA”----- Cinema (Fixed value to focus on tone reproduction for movie)
“CUSTOM1” ------------- Image1
（
the value adjusted and stored by user
）
“CUSTOM2” ------------- Image2
（
the value adjusted and stored by user
）
“CUSTOM3” ------------- Image3
（
the value adjusted and stored by user
）
