PLC-WXU10
10
Step
Figure
Description
1
Press the power button to
shutdown the projector and
disconnect the power cord.
If the lamp is hot, please do
not start any procedure until
the projector lamp cools
down.
Remove the Lens Cover
with strap from the cabinet
bottom.
2
1.Turn the projector over
and remove the filter by
pulling the latches upward
2.Gently clean the filter by
using a brush or rinse it
softly
3.When rinsing the filter ,dry
it well.Replace the filter
properly.make sure that the
filter is fully inserted to the
projector.
4.Remove the one screw on
the lamp cover and open
the lamp cover
Summary of Contents for PLC-WXU10B
