42
APPENDIX
LAMP REPLACEMENT Indicator
When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the
image become dark or the color of the image become unnatural, replacement of the Lamp is required.
Turn off the projector and disconnect the AC plug. Allow
the projector to cool for at least 45 minutes.
Remove a screw with a screwdriver and remove the
Lamp Cover.
1
3
Lamp Replacement Monitor Timer
Remove 2 screws with a screwdriver and pull out the
Lamp Assembly by grasping the handle.
4
Replace the Lamp Assembly and tighten 2 screws. Make
sure that the Lamp Assembly is set properly.
5
Lamp Replacement
Remove the Center Panel of the projector. Pull the lower
part first and remove the Panel.
2
CAUTION
l
For continued safety, replace with a lamp assembly of the same type.
l
Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside
of the projector can become very hot.
l
Do not drop the lamp module or touch the glass bulb! The glass can shatter and may cause
injury.
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp
Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting.
Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT
LEFT/RIGHT buttons to select SETTING
and press the SELECT (REAR CLICK) button (refer to the page 38).
Another dialog box SETTING MENU Menu will appear.
1
Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to Lamp age, and then press the
SELECT (REAR CLICK) button. The message of "Lamp replace monitor Reset?" is displayed.
2
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
Connect the AC Power Cord to the projector and turn the
projector on.
7
Remove a
screw and the
Lamp Cover.
Remove 2 screws and the
Lamp Assembly by grasping
the handle.
Follow these steps to replace the lamp assembly.
Reset the Lamp Replacement Monitor Timer (refer to the
section "Lamp Replacement Monitor Timer" below.)
8
Select [Yes] to reset the Timer.
3
CAUTION
Do not drop the screw inside of
the cabinet.
Replace the Lamp Cover and tighten a screws, and
replace the Center Panel.
NOTE : Be sure to meet the Center Panel and the
projector at the upper part first, and set the
Center Panel securely.
6
Pull the lower part
first and remove.
