Appendix
The command is sent from PC to the projector with the
format below;
'CR' [Command] 'CR'
Command: one character (refer to the command
table below.
The projector decodes the command and returns the
'Character string' with the format below;
Format
The tables on page 90 and 91 show the typical command lists for controlling the projector. Please consult
your local dealer for further information of other commands.
Command
Function
Projector
Return
Projector status
CR0
Status Read
00
Power On
80
Stand-by mode
40
Countdown
20
Cooling down
10
Power Malfunction
28
Cooling down at the temperature anomaly
24
Cooling down at Power Management mode
04
Power Management mode after Cooling down
21
Cooling down after the projector is turned off when the
lamps are out.
81
Stand-by mode after Cooling down when the lamps are out.
88
Stand-by mode after Cooling down at the temperature
anomaly.
2C
Cooling down when the projector is turned off by the shutter
management function.
8C
Stand-by mode after cooling down by the shutter
management function.
CR6
Temperature Read
%1 %2
%3
7HPSHUDWXUHDW6HQVRUÛ&
7HPSHUDWXUHDW6HQVRUÛ&
7HPSHUDWXUHDW6HQVRUÛ&
H[ Û&
,
Û& Û&
--> The projector displays “12.3 23.4 34.5”
(For each sensor, two digit and the tenth place numbers
are displayed with a space between each temperature.)
?
Communication failure
Status Read Command
91
