BACK-UP BATTERY INSTALLATION (Fig. 2)
Connect a standard 9V (006P/6F22) battery (not included) to the snap-on terminal match-
ing the polarity.
NOTE:
If the time display is blinking when the mains returns after a failure, the back-up battery
is exhausted and must be replaced.
BATTERY BACK-UP SYSTEM
This unit incorporates a battery back-up system which protects the clock, sleep timer and
wake-up alarm functions from the mains failure with the battery installed. During the
mains interruption, the clock display will go out, but the clock movement remains in
operation. The time display will be resumed when the mains return.
Reset the time if the display time is incorrect.
When the mains lead is connected to the AC outlet for the first time, or when the mains
returns after a failure longer than the battery life, the display will blink.
In this case, set the clock and timer again.
POWER SUPPLY
Connect the mains lead to an AC 230V, 50Hz wall outlet.
-
The
RADIO AUX/ON/OFF
switch is mounted on the secondary side. The unit is not
disconnected from mains, even switched off.
Earphone
Connect the 1/8-inch (3.5mm) earphone to the
EAR
socket for (mono output) on the back of
the radio for monitoring or for private listening.
The speakers are automatically disconnected when the earphone is connected.
ADJUSTING THE CLOCK
1. Set the
RADIO AUX/ON/OFF
switch to
OFF
.
.
2. While holding the
TIME SET
button down, push the
FAST UP
or
SLOW DOWN
button respectively to select the current time.
3. Release the
TIME SET
button.
4
