•
Please note: The handle will not latch if the toaster is not
connected to the mains supply, and may not latch the browning
control is set to the minimum position.
•
If you should find that the toast is not dark enough you may wish
to toast the bread again. Remember to increase the browning
control setting for subsequent operations. If the toast is to dark,
reduce the browning control before toasting the next slice.
•
When toasting has finished the handle will rapidly rise to the
raised position. Toaster may be stopped at any time by pressing
the
STOP
button.
•
Reheat function.
Simply place cold toast into toaster, press handle right down
until it latches and press
REHEAT
button.
Toaster will operate for a short period only.
•
High lift function.
If the toast is required to be raised higher than standard
position, manually raise the handle and the toasted bread can
now be removed and the toaster is ready to recommence
toasting.
•
Please note
: Dry or thin slices will toast more quickly than moist
or thick slices requiring a lower browning control setting. When
toasting more than one slice at the same time, use a similar size
and consistency of bread to achieve equal browning. There
should be a 3-minute break after 2 uses to allow the toaster to
cool down.
MAINTENANCE AND CLEANING
•
It is important that crumbs are not allowed to build up inside the
base of the toaster. To remove crumbs from inside of your
toaster,
FIRST UNPLUG THE TOASTER,
and ensure the
toaster is fully cooled before proceeding. Pull crumb tray located
on the bottom of the toaster out, discard the crumbs, and slide
the crumb tray back into the toaster, locking into position. Never
touch the internal parts of the toaster with a brush or any other
implement. Do not operate the toaster without the crumb tray in
place.
•
To clean the outer surface of the toaster, use a soft damp cloth
and dry it afterwards with a dry towel. Clean and store only after
unplugging the toaster from the mains supply.
SANYO Electric Co., Ltd
