– 8 –
1-3. INSTALLATION OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1.
Pressing down the door opener lever of the mechanism
main unit.
2.
Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
Fig. 1-1-5
Note
:
Opened cassette door position does not install the front
panel to the chassis.
Fig. 1-1-4
M-RQ4Q/EX-5
1-2. TEMPORARILY SETTING UP AND CONNECTING CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1.
Place the mechanism unit and main board up side down as
a whole on a flat surface with foil side of the main board
facing up.
2.
Operete the unit using the buttons on CP-1 PWB or the
remote control.
M-RF4QR/NA-4
PW-1 PWB
Screws
CP-1 PWB Assembly (Foil side)
TM-1 PWB
Mechanism Main Unit
Terminal Board
Cassette Compartment
TM-2 PWB
Jutted part of
Cassette Holder
Door Opener Lever
Front Panel
Cassette Door
(Position B)
Cassette Door
(Position A)
