1
In [AUTHENTICATION], select the authentication method.
NO USE, POP3, SMTP
2
In [USER ID] and [PASSWORD], type the user ID and password, respectively.
Type the user ID (up to 48 alphanumeric characters) and password for authentication (up to 20 alphanumeric
characters).
3
In [POP3 SERVER ADDRESS], type your POP3 server address and click
SET
.
If you selected “POP3” in [AUTHENTICATION], type the IP address or domain name of your POP3 server (up to
64 alphanumeric characters).
1
In [TRIGGER], select the e-mail transmission conditions.
INTERVAL:
Sends an e-mail at fixed intervals.
ALARM IN1:
Sends an e-mail when the ALARM IN1 terminal receives an alarm signal.
ALARM IN2:
Sends an e-mail when the ALARM IN2 terminal receives an alarm signal.
MOTION:
Sends an e-mail when the motion sensor detects motion in the subject.
ALARM OUT1:
Sends an e-mail when the ALARM OUT 1 terminal outputs an alarm signal.
ALARM OUT2:
Sends an e-mail when the ALARM OUT 2 terminal outputs an alarm signal.
NETWORK
FAILURE:
Sends an e-mail when the camera detects a network failure during network
recording.
A
If you selected “NETWORK FAILURE” ...
In [NETWORK FAILURE TIME], select the time from the occurrence of a network failure until the camera
recognizes it as a recording trigger.
15SEC, 20SEC, 30SEC, 40SEC, 50SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
B
If you selected “INTERVAL” ...
In [INTERVAL], select the interval between e-mail transmissions.
1MIN, 2MIN, 3MIN, 4MIN, 5MIN, 10MIN, 15MIN, 30MIN, 1HOUR, 2HOUR, 3HOUR, 4HOUR, 5HOUR,
6HOUR, 7HOUR, 8HOUR, 12HOUR, 24HOUR
Working with Administrator Configuration Screens 58/71
