TROUBLESHOOTING
Before taking the camera for repairs, please check below to make
sure that the camera is used correctly. If it still does not perform
correctly, please consult your dealer or a Sanyo Authorized Service
Center.
No picture on the monitor screen
•
Is the power turned on to all connected devices? Is the voltage
correct?
•
Are all the signal connecting cables correctly connected?
•
Is the lighting sufficient?
The picture is not clear
•
Is the monitor correctly adjusted?
•
Is the lens focus correctly adjusted?
•
Are the lens surfaces clean?
If there is dust or finger prints on the lens, the image quality will
deteriorate. To clean the lens use a soft cloth or a commercially
available lens cleaning set.
SERVICE:
This camera is a precision instruments and, if treated with care, it
will provide years of satisfactory performance. However, in the
event of a problem, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be referred to
your dealer or Sanyo Authorized Service Center.
SPECIFICATIONS
Camera
TV system
CCIR standard (625 TV lines, 25
frames/sec.)
Scanning system
625 TV lines, 50 field/sec.,
2:1 interlace
Image device
Interline transfer method, 1/3 inch
solid state CCD
Picture elements
537 (H)
×
597 (V)
Effective picture elements
500 (H)
×
582 (V)
Synchronization system
Internal sync.
Resolution
400 TV lines horizontally, 400 TV
lines vertically
Video output signal level
1.0 Vp-p/75
Ω
(screw-on terminal)
S/N ratio
More than 50 dB
Minimum required
illumination
0 lux
Electronic iris range
1/50 to 1/80,000 sec.
Iris system
Electronic iris
Gain control
Automatic
Lens
Built-in, F2.0, f=3.8 mm, fixed focal
lens, focus adjustment
Angle of view
Horizontally: Approx. 71˚
Vertically: Approx. 53˚
Diagonal: Approx. 90˚
L73E2/XE GB 1998, 8, 19
English
9
