Sanyo VCC-9615P, Service Manual

TV system : 

PAL standard (625 TV lines, 25 frames/sec.)

Scanning system

 : 625 TV lines, 50 field/sec., 2:1 interlace

Image device : 

Interline transfer method, 1/3 inch solid state CCD

Picture elements : 

795 (Horizontal) x 596 (Vertical)

Effective picture elements : 

752 (Horizontal) x 582 (Vertical)

Synchronization system : 

Internal sync.

Resolution : 

480 TV lines horizontally, 400 TV lines vertically

Video output signal level : 

1.0 Vp-p/75 

Ω

 (screw-on terminal)

S/N ratio : 

More than 48 dB

Minimum required illumination : 

1.8 lux (F 1.6 lens)

White balance : 

A (Automatic: TTL system)/M (Manual) manual switching

Backlight compensation : 

1 (On)/0 (Off) manual switching,

                                             Active-zone light measuring system

Backlight compensation iris level adjustment : 

Manual LEVEL volume control

Aperture :

 1 (High)/0 (Normal) manual switching

Gain control :

 Automatic

MONITOR output pin : 

1.0 Vp-p/75 

Ω

, test point pin

Lens :

 F1.6 ~ 2.3, f=2.6 ~ 6.0 mm, varifocal lens, manual zoom and focus adjustment

Iris system : 

Mechanical auto iris

Operational environmental conditions : 

Temperature: -10 

°

C ~ + 50 

°

C

                      Humidity: less than 90 %

Storage environmental conditions : 

Temperature: -20 

°

C ~ + 60 

°

C

                      Humidity: less than 70 %

Power supply : 

12-15 V DC/ 24 V AC, 50 Hz

Power consumption

 : 3.5 W

Weight : 

Approx. 420 g

SERVICE MANUAL

COLOUR CCD Camera

VCC-9615P

(Product Code : 117 047 15)
(Europe)

FILE NO.

REFERENCE No. SM5310516

L5AR2/XE

NOTE : 1. Parts order must contain model number, part number, and description.
             2. Substitute parts may be supplied as the service parts.
             3. N. S. P. : Not available as service parts.

Design and specification are subject to change without notice.

The components designated by a symbol (   !   ) in this schematic diagram designates components whose value are of

special significance to product safety. Should any component designated by a symbol need to be replaced, use only the

part designated in the Parts List. Do not deviate from the resistance, wattage, and voltage ratings shown.

PRODUCT SAFETY NOTICE

CONTENTS

1. DISASSEMBLY, VR AND TP LOCATION

AND BOARD LOCATION .................... 2

2. ADJUSTMENT ..................................... 3
3. PARTS LIST ......................................... 5
CIRCUIT DIAGRAM &
PRINTED WIRING BOARDS ................. C1

SPECIFICATIONS