23
Adjusting DAY/NIGHT Function <DAY/NIGHT>
The DAY/NIGHT function automatically switches over between COLOR and B/W
mode depending on the ambient brightness; for example, choosing COLOR mode
during daytime, and B/W mode for nighttime monitoring with its increased
sensitivity in a darker environment. “AUTO” is preselected by default, which
provides an automatic switch feature to detect the ambient darkness. As
appropriate for any specific environment, you can fix the mode to either COLOR
or B/W, and adjust the way the switching function works.
1
Select “DAY/NIGHT” and specify a mode.
R
Image switches immediately after the selection is made.
2
For advanced settings (AUTO or B/W), press the
SET button.
R
Each corresponding settings screen will appear.
• Advance to next page when selecting “AUTO”.
Advance to page 25 when selecting “B/W”.
3
Set “MENU” to “END” and press the SET button.
R
Finishes the setting screen and returns to the normal
monitoring screen.
(VDC-DP7584/
VDC-DP7585P)
Note:
During the switching operation, you may hear switch-over noise
inside the camera or see a distorted picture, but these are not signs
of trouble.
SYNC
BLC
IRIS
WHITE BALANCE
AGC GAIN
GAMMA
SHUTTER
APERTURE
·DAY/NIGHT
OPTION
PRESET
MENU
INT
OFF
SET y
ATW
NORM
0.45
60
HIGH
AUTO y
SET y
OFF
END
·DAY/NIGHT
■
AUTO: (See next page)
Automatically switches between COLOR and B/W mode
depending on the ambient brightness. (DAY/NIGHT function)
■
COLOR
Color image on a steady basis; suitable for always bright
location or conditions.
■
B/W (Black-and-White): (See page 25)
B/W image on a steady basis; suitable when sensitivity is
prioritized.
MEMO:
If a communication option board (VA-50ST) is connected: AUX
command issued from the control devices can switch modes.
If a network option board (VA-50LAN) is connected: AUX
command issued from the control panel on the web browser can
switch modes.
AUX1: Color
AUX2: Black-and-White
AUX3: Auto
For accessing the Main menu, see pages 5 – 7.
L5BH2_BK2_US_XE(GB).book 23 ページ ２００６年３月２日 木曜日 午後８時４１分
