Alarm Settings
1
ALARM REC USE
This function stops any motion that occurs
during alarm setting. After the alarm settings
have been made, change this setting to “USE”
so that alarms can be detected in accordance
with the settings.
2
EXTERNAL ALARM
Select “NC” (normal close) or “NO” (normal
open) to display the external alarm setting menu.
Available settings:
•
OFF: No external alarm input is detected.
•
NC: Normal close (normally closed, but input
is detected when open).
•
NO: Normal open (normally open, but input
is detected when closed).
3
MOTION DETECTOR
When set to “ON”, the MOTION DETECTOR
SET screen is displayed. Sensor marks (
ú
) are
used to set the detection area in this setting
screen.
4
MOTION DETECTOR LEVEL
This sets the sensitivity level for the sensor
marks (
ú
). See p. 38 for details on the sensitivity
level.
5
ALARM MODE
This selects what combination of external alarm
and motion detector is to be used to provide
alarm input. Make this setting when “EXTERNAL
ALARM” is set to either “NC” or “NO” or
“MOTION DETECTOR” is set to “ON”.
The ALARM OUT terminal settings also need to
be made.
Available settings:
•
AND: An alarm is generated when both the
external alarm and the motion sensor receive
alarm input.
•
OR: An alarm is generated when either the
external alarm or the motion sensor receives
alarm input.
6
ALARM OUT
This is used to make settings for a device such
as a buzzer that is connected to the ALARM
OUT terminal at the rear of the camera when an
alarm is input.
When “NC” (normal close) or “NO” (normal
open) is selected, the ALARM OUT MODE or
ALARM OUT TIME menu is displayed.
Available settings:
•
OFF: No alarm is output when an alarm is
received.
•
NC: Normal close (normally closed, but an
alarm is output when open).
•
NO: Normal open (normally open, but an
alarm is output when closed).
7
ALARM OUT MODE
This operation can be used to manually switch to
output to the ALARM OUT terminal regardless of
whether an alarm is being received or not. When
set to “ON”, the REMOTE ALARM indicator is
displayed in the initial screen. (p. 38)
8
ALARM OUT TIME
This sets the alarm duration when the external
alarm or motion detector detects an alarm, or
when the REMOTE ALARM button is pressed
when using the remote function.
The “REMOTE” setting only appears when
“ALARM OUT MODE” is set to “REMOTE
CONTROL”.
Available settings:
2, 5, 10, 15, 20, 30, 60 sec.,
2, 3, 4, 5 min., REMOTE
L5AM2/XE (VCC-WB4000P) GB 2003, 6, 6
English
– 33 –
