INDOORS RECORDING
AC adaptor
I
charger
The AC adaptor/charger is used to power the camcorder
indoors, where an AC outlet is available. It is also used to
recharge your battery pack(s).
The supplied AC adaptor/charger can be used in any
country where the standard voltage is between 100 V and
240 V AC. However, you will have to use a plug adaptor
where the plug standard is different.
1
Connect to DC connecting cord from the DC output
terminal on the AC adaptor/charger to the DC input
terminal on the back of the camcorder.
2
Plug the AC adaptor/charger power cord into an AC
outlet.
�Note:
For this product use the supplied AC adaptor/
charger (conforming to the EIA Japanese
standard, with a unified polarity type plug). Use
of another AC adaptor/charger may cause
trouble.
2
1
9
THIS PLUG IS NOT WATERPROOF•KEEP DRY
This cord is already fitted with a moulded plug
incorporating a fuse, the value of which is indicated on
the pin face of the plug. Should the fuse need to be
replaced, an AST A approved BS 1362 fuse must be
used of the same rating, marked thus<@>.
If the fuse cover is detachable, never use the plug with
the cover omitted. If a replacement fuse cover is
required ensure, it is of the same colour as that visible
on the pin face of the plug (ie red or orange). Fuse
covers are available from the Parts Department
indicated in your User Instructions.
If the plug supplied is not suitable for your socket
outlet, it should be cut off and destroyed. The end of
the flexible cord should be suitably prepared and the
correct plug fitted.
WARNING: A PLUG WITH BARED FLEXIBLE
CORDS IS HAZARDOUS IF ENGAGED IN A LIVE
SOCKET OUTLET.
IMPORTANT
The wires in this mains lead are coloured in
accordance with the following code:
Blue=
Neutral
Brown= Live
As these colours may not correspond with the
coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured Blue must be connected to
the terminal in the plug which is marked with the letter
N or coloured Blue or Black. The wire which is
coloured Brown must be connected to the terminal
which is marked with the letter L or coloured Brown or
Red.
WARNING: DO NOT CONNECT EITHER WIRE TO
THE EARTH TERMINAL WHICH IS MARKED WITH
THE LETTER E, BY THE EARTH SYMBOL
...J.,..
OR
COLOURED GREEN OR GREEN/YELLOW.
