EN-31
Saturation
This sets the saturation of the image that will be captured.
* High / Standard / Low
Metering
This sets the metering method for calculating the exposure.
Capture Md.
This sets the recording method at the time of capturing images
.
Quick Shot
If this function is set to “On”, the camera takes a quick shot without focusing.
* On / Off
Digi. Zoom
This sets whether or not to use digital zoom at the time of photography.
* On / Off
Date Print
The date of recording can be printed directly on the still images. This function must be
activated before the image is captured.
* On / Off
Setup
Refer to the section in this manual titled “Setup Menu” for further details.
* Center:
Averages the light metered from the entire frame, but gives greater
weight to the subject matter at the center.
* Spot:
A very small portion of the center of the screen is measured to calculate
the correct exposure.
* Average:
The exposure is measured all of the image area.
* Single:
Captures one image at a time.
* Continuous:
Permits continuous capture of up to 3 images.
* AEB:
Permits 3 consecutive images in the order of standard exposure,
underexposure and overexposure compensation.
* Burst:
Permits continuous photography while pressing and holding the shutter
button. As long as you hold the shutter button pressed, images are
captured until the memory capacity is exhausted.
* Cont. flash:
Permits continuous capture of up to 3 images with flash.
* Pre-shot:
Select a background by 1st shot, the image shown on display will be
transparent, then take the 2nd shot on the basis of 1st image. Image of
1st shot is only a guiding tool, it won't be saved on SD card. Normally this
function is used when taking a portrait picture and the background is
selected by the model instead of the photographer.
* Coupl.shot:
Uses separate areas to combine two shots. You can include yourself in
the shot.
Summary of Contents for VPC-S1415
