− 8 −
1-4. PW1 POWER CIRCUIT DESCRIPTION
1. Outline
This is the main PW1 power circuit, and is comprised of the
following blocks.
Switching controller (IC501)
Digital and analog system and 5.0 V system power output
(L5010, Q5002, D5013, C5061)
Digital 3.3 V system power supply (L5017, Q5006, D5004,
C5062)
Digital 3.4 V system power supply (L5001, Q5006, D5004,
C5060)
Analog and LCD system power supply (Q5007, T5001)
2. Switching Controller (IC501)
This is the basic circuit which is necessary for controlling the
power supply for a PWM-type switching regulator, and is pro-
vided with four built-in channels, only CH1 (digital 3.3 V), CH3
(5 V system), CH2 (digital 3.4 V) and CH4 (analog and LCD
system) are used. Feedback from 3.3 V (D) (CH1), 3.4 V (D)
(CH2) , 5.0 V (D) (CH3) and +15.0 V (A) or +12.4 V (L) (CH4)
power supply outputs are received, and the PWM duty is var-
ied so that each one is maintained at the correct voltage set-
ting level.
2-1. Short-circuit protection circuit
If output is short-circuited for the length of time determined
by the condenser which is connected to Pin (17) of IC501, all
output is turned off. The control signal (P ON, P(A) ON and
LCD ON) are recontrolled to restore output.
3. Digital 3.3 V Power Output
3.3 V (D) is output. Feedback for the 3.3 V (D) is provided to
the switching controller (Pins (1) of IC501) so that PWM con-
trol can be carried out.
4. Digital 3.4 V System Power Output
3.4 V (D) is output. Feedback is provided to the swiching con-
troller (Pin (12) of IC501) so that PWM control can be carried
out.
5. 5 V System Power Output
5 V (D) and 5.1 V (A) are output. Feedback for the 5 V (D) is
provided to the switching controller (Pin (25) of IC501) so
that PWM control can be carried out.
6. Analog and LCD System Power Output
15.0 V (A), -8.0 V (A), 12.4 V (L) and 15 V (L) are output.
Feedback for the 15.0 V (A) with view mode and 12.4 V (L)
with play mode is provided to the switching controller (Pin
(36) of IC501) so that PWM control can be carried out.
