6
Appendix
Appendix
No image
– Check the connection between your computer or video equipment
and the projector. See pages 18-20.
– See if the input signal is correctly output from your computer. Some
laptop computers may need to change the setting for monitor output
when connecting to a projector. See your computer’s instruction
manual for the setting.
– It takes about 30 seconds to display an image after turning on the
projector. See page 21.
– Check the Input singal, color system, video system or computer
system mode.
– Make sure the temperature is not out of the specified Operating
Temperature (
41˚F–95˚F [5˚C–35˚C])
.
– When "No Show" is operating, the image cannot be displayed. Press
the NO SHOW button or any other button on the remote control.
No sound
– Check the audio cable connection from audio input source.
– Adjust the audio source.
– Press the button. See page 26.
– Press the Mute button. See page 26.
– When the AUDIO OUT is plugged-in, the projector's built-in speaker
is not available
– Is the image projected? You will hear the sound only when the image
is projected.
The color is strange .
– Check the Input signal, color system,video system or computer
system mode.
– Make sure the "Blackboard" is not selected on Image select
menu.(see page 35,42)
Some displays are not seen
– Check the Display function. See page 47.
during the operation .
Auto PC adjustment function
– Check the Input signal. Auto PC function can not work when
does not work .
480p,575p.720p,480i,575i,1035i or 1080i is selected or when the
digital signal is input into DVI terminal.(see Page 32)
– The icon is not available in grayout when the digital signal is input.
The setting does not remain
– Make sure you selected "Store" after adjusting setting. Some settings
after turning off power .
can not be stored if not registered with "Store".(see page 37,44)
Power management does
– Power management function can not work while "Freeze" or "No
work .
Show" function is running.(see page 51)
Capture function does not work .
– Check the connection and the input signal to see if there is signal.
Auto setup does not work properly .
– Make sure "Off" is not selected at the Auto setup function.(see page
25,46)
– Make sure "On" is not selected at the Ceiling funtion.(see page 50)
Auto keystone function does not
– Make sure the Auto keystone function is not set to "Manual". Press
work even when the projector is
the AUTO SET UP button on the top control.(see page 25,46)
tipped .
Summary of Contents for XU88 - PLC XGA LCD Projector
Page 2: ... ...
Page 77: ...KD3AC A SANYO Electric Co Ltd ...
