Page 8 of 9
9
Fixed Panel Installation - Install the “peel-and-stick”
Wall Seal [I I] on the wall side edge of the Fixed Panel.
Orient it with the open end to the inside of the enclosure.
Lift the Fixed Panel and set it in the Glass Clips with the
edge as tight to the wall as possible. Loosen the Set
Screws in the wall mount sleeves and slide them over the
Wall Mount Blocks. Snug the Set Screws into the block
(
DO NOT TIGHTEN
).
10
Door Panel Installation – Lift the Door Panel [P]
and place the rollers on the bar, making sure to
get the bottom edge of the Door Glass into the Center
Guide. To adjust the door glass height, Adjustments must
be made to the Bar height. Adjustments can be made in
the wall mount blocks (See step 4) as well as the Glass
Mounts. Once you have the Header Bar set as you want
it, and the Fixed Panel positioned correctly, tighten the
Wall Mount Set Screws, then the Glass Mount Screws and
Caps.
CAUTION: Do not remove both Glass Mount
Caps at the same time.
Install the anti-Jump [X] and
Anti-Jump Screws [Y] on both Roller Assemblies.
