_
English
_
USING INSTRUCTIONS
1.
Your clipper was examined to ensure that the blades were oiled and aligned before leaving
the factory.
2.
Add a few drops of oil to the blades, turn clipper on for a few seconds before trimming.
Then turn off and unplug it. Using a damp cloth wipe the clipper body to avoid oil spatter
on people’s hair. Loosen screws slightly and adjust the blade, tighten screws after blade is
aligned.
3.
While using the hair clipper there could be some noise, vibration and heating. Please don’t
worry. This is the normal phenomenon and does not affect the clipper performance.
4.
Please always keep the clipper clean and regularly drop oil to lubricate the blades.
5.
After replacing or cleaning, the blades should be realigned.
INSTRUCTION FOR HAIR CUTTING
Before starting the hair cut:
1.
Inspect the clipper, making sure that it is free of oil between the cutting blade teeth and
turn the unit on to distribute the oil and to make sure it is running smoothly. Wipe off any
excess oil. This should be done after each use. While using the unit, untwist the cord from
time to time to avoid tangling.
2.
Seat the person so their head is approximately at your eye level. This allow ease of
visibility while cutting and a relaxed control of the unit
3.
Before cutting always first comb the hair so it is tangle free and as it is naturally worn.
4.
Place a towel around the neck and shoulders of the person having the haircut.
Reminders
•
Cut the hair in a relaxed and slow manner. Use short strokes only to work gradually over
the entire head.
•
Always take off a little hair at a time; you can always trim off additional hair later.
•
As you work, comb the hair frequently back into the style to which you are cutting.
•
When cutting with this hair clipper it is better to leave the hair dry, not wet. With the hair
dry, it is much easier to control the amount of hair being cut.
The clipper had been adjusted to the best working condition and designed to be used in 220V,
~50Hz voltage range before leaving the factory. The clipper will produce some strange noise
when having a high voltage while it is operating. At this time you just need the equipped
adjuster to loosen the adjust screw in anti-clockwise direction until decline down the noise.
When having a low voltage the clipper blade will operate with less power and narrow moving
range. At this condition, you just need to do the opposite operation to above.
