_
English
_
Steam Iron
SP-1050-AKC
INSTRUCTION MANUAL
Part Identification
1.
Spray button
2.
Steam button
3.
Water filling inlet
4.
Spray nozzle
5.
MAX. water level
6.
Ceramic Soleplate
7.
Temperature control dial
8.
Transparent water tank
9.
Pilot lamp
Important
•
Ensure that the voltage in the electrical network is the same as that on the type plate.
•
The iron should always be turned off before plugging or unplugging the power cord.
•
Never yank the cord while unplugging it from the outlet! Instead, grasp the plug and
pull it to unplug.
•
Never use the appliance if it is damaged in anyway.
•
When leaving the iron, even when only a short while, always unplug the power cord.
•
Close supervision is necessary for any appliance being used by or near children.
•
Do not leave the iron unattended while connected or it is on the ironing board.
•
Burns can occur from touching hot metal parts, hot water or steam.
•
Be careful when you turn the steam iron upside down - there may be hot water in the
reservoir.
•
Never immerse the iron in water.
•
Always place the iron with its back on a firm flat surface when interrupting ironing or
after use.
•
Keep the soleplate smooth. Avoid hard contact with metal objects.
•
The cord should not be allowed to touch the soleplate when it is hot.
•
When using the iron for the first time, test on an old piece of fabric to ensure that the
soleplate and water tank are completely clean.
•
Your iron is designed to rest on its heel. Do not leave the iron unattended when
switched on. Do not place the iron on an unprotected surface even if it is on its heel
rest.
Filling With Water
•
Ensure that the power cord is unplugged from the outlet.
•
Turn the steam control knob to position ”0”
•
Fill with water through water filling inlet. (Do not exceed main level mark on the
water tank.)
Setting the Temperature
**Synthetics-silk
