4
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Identify Your Clock
The capabilities of your clock may be determined by looking at the clock’s part number. A
label containing the part number of your clock is attached to the clock packaging.
Look at the second group of letters in the part number.
Group Code
Synchronization Module
Wi-Fi Capabilities
WWB
Wi-Fi Network Adapter
Synchronization and Configuration
WPB
IP LAN Cable Network Adapter
Configuration Only
WSB
GPS Receiver
Configuration Only
WLB
900MHz Wireless Receiver
Configuration Only
WGB
2.4GHz Wireless Receiver
Configuration Only
WTB
900MHz TalkBack Receiver
Configuration Only
WTGB
2.4GHz TalkBack Receiver
Configuration Only
WDB
Wired (2-wire,RS485,Sync)
Configuration Only
For clock size, refer to the fourth group of digits of your part number
.
Size Code
Size of Digits Number of Digits
0604
6” (15.2cm)
Four
0606
6” (15.2cm)
Six
0904
9” (22.9cm)
Four
0906
9” (22.9cm)
Six
1204
12” (30.5cm)
Four
1206
12” (30.5cm)
Six
Clocks with 4” or 2.5” digits are NOT Large Digital Clocks.
For power source information, refer to the last digits of your part number
.
If the part number ends in
4
, the clock requires a 24V power source.
If the part number ends in
12
, the clock requires a 110VAC or 230 VAC power source
If the part number ends in
0
, the clock requires its power from a Power-over-Ethernet (PoE) switch or
injector.
The pictures provided in this manual are designed to accommodate
the maximum number of models and configurations for this product.
The clock that you order may appear slightly different than the one
shown in the pictures, depending on the ordered synchronization
system, number of digits, digit size, and mounting configuration. For
example, the circuit board for the IP LAN cable network adapter will
appear in all pictures of the main board in this manual, but will only
be included in WPB models of the clock.
After identifying your clock, go to the “Preparing to Install - Network Requirements” page for your system.