Pump connection
Release valve open (gate)
Release valve open (inline)
slide filter face upwards
unwrap your new spa
what do I do first?
Inspect for damage
Carefully unwrap your spa and thoroughly inspect
it for any damage. If you notice any transit damage
to your product, please photograph the damage,
keep all paperwork/labels and contact the dealer
from which the spa was purchased immediately.
Rotate jets
Rotate all jets to the ‘on’ position.
Wipe out excess water
Your Sapphire Spa has been thoroughly factory
tested during the manufacturing process to ensure maximum
reliability and long term satisfaction. Wipe out any excess
water from the spa that may have drained from the plumbing
after testing and make sure the spa
is clean prior to filling.
Check pump connection and release valves
Prior to filling your spa, remove the side panels where
the engine compartment and control equipment are
situated. Ensure all your pump connections are tight
and release valves are
open as they may have shifted during transit.
Remove filter tray & cartridges
Slide filter face upwards, then remove filter
tray cover & filter cartridges before filling
(2 x cartridges in spa pools / 4 x cartridges
in swim spas)
Check air controls
Ensure all air controls on the topside of your
spa are turned to the ‘off’ position. Failure
to turn off the air controls will extend your
heat up time dramatically.
Warning: It is important that home owners comply with state and council regulations which are in place to improve
safety outcomes. Additional information can be obtained from your local council or please visit spasa.com.au
VIDEO INSTRUCTIONS
Visit the mySpa@Home support page
sapphirespas.com.au/myspa-at-home
for video instructions.
Owners Manual
|
7
6
|
Owners Manual
Summary of Contents for myHotTub
Page 1: ...Spaownersmanual ...
