DO NOT fill spa by placing hose in the foot well
Filling a spa this way will create a large number of
air pockets in the pipe work and may cause difficulty
when priming. Always fill spa through the filter area.
Double check release valves are open
Remove cabinet doors (using allen key supplied)
and double check that all release valves (refer step
one – inspection) in the plumbing system are fully
open to maximise the amount of air that can escape
the pipe work during filling.
Fill spa to the correct level
Fill the spa to the half way point of the filter weir
to ensure adequate water flow.
Remove filter cartridge(s) before filling
Remove filter cartridge(s) before filling
to enable filling of the spa through the filter itself.
This will flood the pipe work with
water and minimise the chance of air
pockets forming in the plumbing during
the filling process
Initiate water priming sequence
Every time the power is turned on the SV controller
will initiate a water priming sequence on start up.
During priming sequence the filtration pump will run
for up to 20 seconds at a time in an attempt to purge
air from the plumbing. The keypad display will scroll
PRIMING during this sequence. If the spa controller is
successful in clearing all of the air from the pipe work,
the system will begin normal operation. However, if
air is still detected the spa controller will shut down
and display a fault code ‘ER3-Water Prime’ (refer to
trouble shooting).
Fill to here
filling your spa
almost time to jump in
MANUFACTURER RECOMMENDATION:
DO NOT FILL YOUR SPA WITH
HOT WATER!
The acrylic surface of your spa is designed
to be warmed slowly and evenly by the
inbuilt heating system
Owners Manual
|
15
14
|
Owners Manual
Summary of Contents for myHotTub
Page 1: ...Spaownersmanual ...
