4 Charge
Connect the SR-TM1 with the provided USB cable to a travel adapter, a computer
(slower charging speed) or any other USB port which provides standard 5 volts. It
will automatically start charging and all the 5 buttons will flash blue in cycles.
When the SR-TM1 has been fully charged, the 5 buttons will stay blue.
Pull out the cable and long press the power button to restart , now the SR-TM1 is
ready to use.
5 Highlights
• -10 dB Pad
Attenuates the microphone input to allow for the recording of loud sounds
without clipping.
• 150 Hz High Pass Filter
Reduces low frequency and infrasonic rumble from HVAC systems indoors or
street traffic outdoors from over-powering the recording.
• High Frequency Boost
Restores some of the high frequency content that is often lost when a blimp or
furry windshield is placed over the microphone and improves the intelligibility of
recorded speech.
• Rechargeable built-in Li-ion battery
The built-in battery supports at least 150 hours operation.
6 Specification
Acoustic Principle
Line gradient
Directional Pattern
Cardioid
Frequency Range
40 to 20k Hz (selectable HPF 150 Hz)
Sensitivity
-35±3dB(0dB=1V/Pa,at 1KHz) 1.5V 2.2k
Ω
Output Impedance
200 ohm
Maximum Output
10 dBu (at 1 kHz, 1% THD into 1 kOhm)
Dynamic Range
119 dB (per IEC651)
Maximum SPL
135 dB
Signal to Noise Ratio
75 dB SPL (per IEC651)
Power
48V phantom power; built-in lithium battery (battery
life:150 hours)
Output Connection
3-pin XLR, balanced output between Pin 2 (+), Pin 3 (-) and
Pin 1 (ground)
Dimensions
2.3 x 2.3 x 28.2 cm
Weight
171g (About 6 oz.)
7 Packing List
• Micro USB cable
• Mic Clip
• Foam windshield
• SR-TM1 microphone
• XLR Cable
POLAR PATTERN
FLAT
HIGH BOOST
LOW CUT 150HZ
