Page:21
Enabling the Time Delay Override (TDO) Type
If the time delay has already been set, enter a User Code to start the time delay. When the time delay expires (the lock
emits 10 rapid beeps) and the opening window has begun, immediately proceed to change the time delay by performing
the following steps:
Step 1
Enter: 4 6 *
Step 2
Enter: 8-digit Programmer Code #
♪♪♪♪♪
Step 3
Enter: Time Delay Override Type (1 or 2) #
♪♪♪
Step 4
Enter: Time Delay Override Type (1 or 2) #
♪♪♪
TDO Set Type
Enter Code
********
Enter Option
Enter 0,1,2
Confirm Option
Enter 0,1,2
Example
To enable TDO type 2:
Step 1
Enter: 4 6 *
Step 2
Enter: 0 0 1 2 3 4 5 6 #
♪♪♪♪♪
Step 3
Enter: 2 #
♪♪♪
Step 4
Enter: 2 #
♪♪♪
TDO Set Type
Enter Code
********
Enter Option
Enter 0,1,2
2
Confirm Option
Enter 0,1,2
2
The TDO TYPE 2 function has now been enabled. The code in position 29 can now be used to open the lock without
waiting for the time delay countdown.
If a time delay value has already been entered, then any
changes to the time delay override feature must be made
during the opening window.
3
.
20
—
Command 47: Setting up the Time Delay
The A-Series with Display
TM
Lock can be programmed with a time delay feature. Time delay applies only to those users
who can open the lock. The time delay can be set from 0 to 99 minutes. If the lock is in the time delay period, the red LED
light on the keypad flashes and a single beep sounds every 10 seconds.
When the time delay expires, the lock emits 10 rapid beeps to indicate that the opening window has started and the lock
can now be opened. During this opening window, the lock beeps and the red LED flashes twice every 10 seconds.
The opening window factory default is set for 2 minutes, and the opening window can be set from 1 to 99 minutes.
To open the lock when a time delay has been programmed, a User must enter their User Code to start the time delay
period, wait the length of the time delay period, and then enter a valid User Code during the opening window.
If the lock is not opened during the open window period, it automatically resets and the process must be repeated. The
lock comes from the factory with no time delay set. If the time delay has already been set, changes to the opening
window and time delay duration can only be made during the opening window.
