27
630-600
MODEL 6128/6129 PROGRAMMING & OPERATIONS GUIDE
Step 5.
Lock indicates successful result with Green “Status 1” indicator
and three beeps .
Step 6.
User removes touch key .
4.3.3 — Download Audit Log:
This is a management only operation code that is used to download the audit log of the lock .
This code does not open the lock . The lock’s entire audit log is transferred to the touch key for
uploading and reporting at the Lock Management System .
Example
Step 1.
User places his management touch key in reader .
Step 2.
User inputs his four digit PIN & and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
The Amber “Mode” indicator will remain illuminated during the transfer of
the audit data to the touch key . This step takes approximately 15 seconds .
Step 6.
At the successful completion of the audit data transfer the lock will flash
the Green “Status 1” indicator and emit three audible beeps .
Step 7.
User removes touch key .
4.3.4 — Reset User Touch Key:
This operation code may be created for Users and Management Users to reset the users
touch key in the event that the user did not successfully capture the “secure” code from the
previous transaction . This code does not open the lock .
Example
Step 1.
User places his touch key in reader .
Step 2.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
At the successful completion of the reset touch key operation, the lock will
flash the Green “Status 1” indicator and emit three audible beeps .
Step 6.
User removes touch key .
4.3.5 — Using the Duress Alarm Feature:
The optional duress module must be connected to the lock and your alarm system for this
feature to work . A duress alarm is sent by entering a valid 5-digit PIN and entering the 4th PIN
digit twice, followed by any valid operation code . If your PIN is 1234 and your operation code is
12345678, you would enter 12344# 12345678# . This would send the duress signal, store
a duress event in the touch key audit trail, and store a duress event in the lock audit trail .
