28
630-600
MODEL 6128/6129 PROGRAMMING & OPERATIONS GUIDE
4.3.6 — Set Clock Calendar:
This is a management only operation code that is used to reset the clock calendar setting
inside the lock . This code operates under specific parameters that are detailed in the Lock
Management System instructions . When this code is used, the lock will derive the date
information from the management touch key, however the time must be input through the keypad
by the user . The time should be set in HHmm format based on a 24-hour clock, where HH =
hours and mm = minutes . It is important to note that the time to be set is the local standard time
at the lock location . This code will not open the lock .
Example
Step 1.
User places his touch key in reader .
Step 2.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code
Step 5.
At the successful completion of the processing the lock will flash the
Green “Status 1” indicator and emits five audible beeps .
Step 6.
User inputs new time on keypad in HHmm format and presses the # key
Step 7.
Lock responds with Green “Status 1” indicator and
emits three audible beeps .
Step 8.
User inputs time on keypad (HHmm) and presses the # again to confirm
Step 9.
Lock responds with Green “Status 1” indicator and emits
three audible beeps .
4.3.7 — Reset Lockout:
This is a management only operation code . This operation is used to reset the lock once it
is set in a lockout mode due to excessive unauthorized attempts to operate the lock with invalid
operation codes or bank user PIN codes . This code will not open the lock .
Example
Step 1.
User places his management touch key in reader .
Step 2.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
At the successful completion of the reset operation, the lock will
flash the Green “Status 1” indicator and emit three beeps .
Step 6.
User removes touch key .
