29
630-600
MODEL 6128/6129 PROGRAMMING & OPERATIONS GUIDE
4.3.8 — Revoke Dispatcher:
This is a management only operation code that is used to transfer the identity of a
subcontractor system to the locks table in order to prevent the subcontractor from
performing any subsequent operations at the lock . This code will not open the lock . To
reinstate the revoked dispatcher requires an “Add Dispatcher” command .
Example
Step 1.
User places his management touch key in reader .
Step 2.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
At the successful completion of the reset operation, the lock will
flash the Green “Status 1” indicator and emit three beeps .
Step 6.
User removes touch key .
4.3.9 — Add Dispatcher:
This is a management only operation code that is used to reset the privileges of a
subcontractor system that was previously revoked using the revoke a dispatcher code . This
code will not open the lock .
Example
Step 1.
User places his management touch key in reader .
Step 2
.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
At the successful completion of the reset operation, the lock will
flash the Green “Status 1” indicator and emit three audible beeps .
Step 6.
User removes touch key .
4.3.10 — Un-install Lock:
This is a management only operation code that is used to return the lock to its default Bank
Operating Mode . Once this operation code is successfully performed, no new Service Mode
operations are possible until the lock is initialized for Service Mode again .
Example
Step 1.
User places his management touch key in reader .
Step 2.
User inputs his four digit PIN and presses the # key .
Step 3.
User inputs the eight digit operation code and presses the # key .
Step 4.
Lock illuminates Amber “Mode” indicator during processing of code .
Step 5.
At the successful completion of the reset operation, the lock will
flash the Green “Status 1” indicator and emit three audible beeps .
Step 6.
User removes touch key .
