Sargent Assa Abloy IN120, Installation Instructions Manual

8          1-800-810-WIRE • www.sargentlock.com • A8152C 

Copyright © 2014, Sargen

t Manufacturing Company

, an A

SS

A AB

LO

Y G

roup company

. All right

s reser

ved

. 

Reproductions in whole or in par

t without express writ

ten permission of Sargen

t Manufacturing Company is prohibited

.

12/20/13

IN120 Cylindrical Lock  

Install strike in the door frame (Fig. 2).

2   Install Strike

Fig.  2

Centerline of Latch 

Front and Strike

(2) #8-32 x 3/4"  

Latch Screws

1.  Install latch with beveled bolt facing the strike.
2.  Attach with two screws but DO NOT tighten completely at this time.                 

           See section 

8 - Secure Lock to the Door

.

3   Install Latchbolt

Fig.  3B

Strike

IMPORTANT: Latch bevel must match door bevel and 
deadlocking latch must stop on strike when door is closed.

Deadlocking Latch

Inside of Door

Fig. 3A

4   Install Door Position Switch (DPS)

1.  Push wires through raceway toward lock prep.
2.  Push DPS firmly into place by hand.

           Note: DO NOT TAP SWITCH WITH ANY TOOL.

3.  Install magnet into door frame. Push firmly into place by hand.  

            See A7983A. 

4.  To connect DPS to lock controller per diagram, refer to the wiring in  

            Step #14 section 3.

Fig. 4

Inside of Door

DPS                           

(Door Position Switch)

CAUTION: if DPS is not installed or is installed 

improperly, door status monitoring features will 

not function.